Item: EVO 3 4G63T motor harness modded to make fitting a 4G63T into your GSR a plug an play afair..
Item Condition: Mint..
Price: $120. ( plus delivery )
Location: Wallerawang, NSW.
Preferred Contact Method: Reply here, PM me
Extra Info:
This harness has been modified so that it will plug into your GSR's wiring harness.. List mods done are :
* Had the extra wiring for the rear wiper washer an intercooler sprayer removed. (not needed for a GSR)
* Had the front wiper washer wiring removed and GSR wiring installed.
* Had the extra wires removed for climate control A/C and had GSR A/C wiring installed
* Had the exhaust temp sensor wiring removed as its not needed in a GSR and the pin locations are required for the brake fluid level sensor on a GSR.
* Had the master cylinder brake fluid level sensor wiring installed correctly for a GSR.
* Had 4 brand new quick release injector plugs installed.
* Also included is the extra 4 wires that are needed for the engine bay harness these are the wires for the alternator and the oil pressure sensor. These were removed
from a factory EVO 3 engine bay harness.
* Also included is the correct 4 pin connector that replaces the GSR's 6 pin connector that sits along the drivers side chassis rail in the engine bay wiring harness..
If the person that buys this needs help on how to install these extra 4 wires I'd be more then happy to help with that also..
Once these extra 4 wires are run with your engine bay harness this will be a plug an play setup to install a 63 in your GSR and it will look factory....
Pictures:
Complete motor harness..
These are the newly installed quick release injector plugs..
And these are the extra 4 wires including the alternator plug..
Edited by 94 GSR, 16 June 2014 - 04:37 PM.
Back to top
